HP JG236A - HPE 5120-24G-PoE+ EI Switch with 2 Interface Slots

Hewlett Packard Enterprise A 5120-24G-PoE. Basic switching RJ-45 Ethernet ports quantity: 24. MAC address table: 32 entries, Switching capacity: 144 Gbit/s. Networking standards: IEEE 802.3,IEEE 802.3ab,IEEE 802.3at,IEEE 802.3u. Power over Ethernet (PoE). Rack mountingThe HP 5120 EI Switch Series are Gigabit Ethernet switches that support static Layer 3 routing, diversified services, and IPv6 forwarding, as well as provide up to four 10-Gigabit Ethernet (10 GbE) extended interfaces. Unique Intelligent Resilient Framework (IRF) technology creates a virtual fabric by managing several switches as one logical device, which increases network resilience, performance, and availability while reducing operational complexity. These switches provide Gigabit Ethernet access and can be used at the edge of a network or to connect server clusters in data centers. High scalability provides investment protection with two expansion slots, each of which can support two-port 10 GbE expansion modules. High availability, simplified management, and comprehensive security control policies are among the key features that distinguish this series. -В Broadcast control: allows limitation of broadcast traffic rate to cut down on unwanted network broadcast traffic -В Friendly port names: allow assignment of descriptive names to ports -В Auto-MDIX: automatically adjusts for straight-through or crossover cables on all 10/100/1000 ports -В Nonblocking architecture: up to 192 Gbps nonblocking switching fabric provides wire-speed switching with up to 143 million pps throughput -В Separate data and control paths: keeps control separated from services and keeps service processing isolated; increases security and performance -В 16K MAC address table: provides access to many Layer 2 devices -В Address Resolution Protocol (ARP): determines the MAC address of another IP host in the same subnet; supports static ARPs; gratuitous ARP allows detection of duplicate IP addresses; proxy ARP allows normal ARP operation between subnets or when subnets are separated by a Layer 2 network