HPE ARUBA IAP-315 802.11n ac Dual 2x2:2 4x4:4 MU-MIMO Wireless AP (US), FIPS TAA

23.00 oz

Access point, mounting clips, documentation

SPECIFICATIONS:

- AP type: Indoor, dual radio, 5 GHz 802.11ac 4x4 MIMO and 2.4 GHz 802.11n 2x2 MIMO
- Software-configurable dual radio supports 5 GHz (Radio 0) and 2.4 GHz (Radio 1)
- 5 GHz: Four spatial stream Single User (SU) MIMO for up to 1,733 Mbps wireless data rate to individual 4x4 VHT80 or 2x2 VHT160 client devices
- 2.4 GHz: Two spatial stream Single User (SU) MIMO for up to 400 Mbps wireless data rate to individual 2x2 VHT40 client devices (300 Mbps for HT40 802.11n client devices)
- 5 GHz: Four spatial stream Multi User (MU) MIMO for up to 1,733 Mbps wireless data rate to up to three MU-MIMO capable client devices simultaneously
- Support for up to 255 associated client devices per radio, and up to 16 BSSIDs per radio
- Supported frequency bands (country-specific restrictions apply):
-- 2.400 to 2.4835 GHz
-- 5.150 to 5.250 GHz
-- 5.250 to 5.350 GHz
-- 5.470 to 5.725 GHz
-- 5.725 to 5.850 GHz
- Available channels: Dependent on configured regulatory domain.
- Dynamic frequency selection (DFS) optimizes the use of available RF spectrum.
- Supported radio technologies:
-- 802.11b: Direct-sequence spread-spectrum (DSSS)
-- 802.11a/g/n/ac: Orthogonal frequency-division multiplexing (OFDM)
- Supported modulation types:
-- 802.11b: BPSK, QPSK, CCK
-- 802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM
- Transmit power: Configurable in increments of 0.5 dBm
- Maximum (conducted) transmit power (limited by local regulatory requirements):
-- 2.4 GHz band: +18 dBm per chain
-- 5 GHz band: +18 dBm per chain
-- Note: conducted transmit power levels exclude antenna gain. For total (EIRP) transmit power, add antenna gain
- Advanced Cellular Coexistence (ACC) minimizes interference from cellular networks.
- Maximum ratio combining (MRC) for improved receiver performance.
- Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance.
- Short guard interval for 20-MHz, 40-MHz, 80-MHz and
160-MHz channels.
- Space-time block coding (STBC) for increased range and
improved reception.
- Low-density parity check (LDPC) for high-efficiency error
correction and increased throughput.
- Transmit beam-forming (TxBF) for increased signal
reliability and range.
- Supported data rates (Mbps):
-- 802.11b: 1, 2, 5.5, 11
-- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
-- 802.11n: 6.5 to 600 (MCS0 to MCS31)
-- 802.11ac: 6.5 to 1,733 (MCS0 to MCS9, NSS = 1 to 4 for VHT20/40/80, NSS 1 to 2 for VHT160)
- 802.11n high-throughput (HT) support: HT 20/40
- 802.11ac very high throughput (VHT) support: VHT 20/40/80/160
- 802.11n/ac packet aggregation: A-MPDU, A-MSDU

ENVIRONMENTAL PROPERTIES:

Operating Temperature: 32 to 122 F (0 to 50 C)
Storage Temperature: -40 to 158 F (-40 to 70 C)
Operating Humidity: 5 to 95%, non-condensing
MTBF: 916,373 hours at 77 F (25 C)

Minimum Operating System Software Versions:
- ArubaOS 6.5.0.0
- Aruba InstantOS 4.3.0.0

1.9"h x 7.2"w x 7.1

(4) Integrated Dual-band Down-tilt Omni-directional Antennas, 4x4 MIMO
(1) 10/100/1000Base-T RJ-45 auto-sensing, 802.3az compatible
(1) USB 2.0 Type A
(1) Bluetooth Low Energy
(1) Serial Console

Supports direct DC power and Power over Ethernet
- DC takes priority
Direct DC Source: 12V DC, nominal, +/- 5%
- Inteface accepts 2.1/5.5mm center-positive circular plug w/9.5mm length
Power over Ethernet: 48V DC (nominal), 802.3af/at compliant
Maximum (worst-case) power consumption:
- 14.4W (802.3at PoE)
- 13.6W (802.3af PoE)
- 12.7W (DC)
Maximum (worst-case) power consumption in Idle mode:
- 6.4W (PoE)
- 5.9W (DC)

This product is subject to our return policy. Please see our complete return policy for details.

1.87 lbs

43222631